What are the regular replacement steps for the filter element of precision filter?

        Speaking of precision filter filter filter elements need to be replaced regularly, may be many friends are not quite aware of it, today, Anping Warner small braid to take you to understand it. PRECISION FILTER ELEMENT REPLACEMENT STEPS: 1. Stop the machine and remove the upper manhole cover. 2. UNSCREW the pressure nut of the filter element, remove the pressure plate to take out the filter element, and rinse the equipment with water. 3. Remove the upper and lower locating rings of the two ends of the filter core and clean them with water, then insert the two ends of the new filter core respectively. 4. One end of the lower locating ring of the new filter cartridge band is inserted into the hole of the porous plate. 5. The upper locating ring of the filter element is inserted into the corresponding pressing plate hole, and the pressing nut is screwed tightly. 6. After installing the filter element, install the upper manhole cover plate and turn on the machine to open the water 7. Open the Inlet Valve, exhaust valve, when the water is full of the equipment, open the net valve, close the exhaust valve, observe the discharge of clean water, wait for the water without foam, then put into normal operation. These are the conventional replacement filter filter elements some steps, different filter replacement methods are not the same, we can draw inferences from one to the other to deal with.